Electronic Inverter Low-Noise Concrete Vibrator Shaft

Electronic Inverter Low-Noise Concrete Vibrator Shaft

Electronic Inverter Minimal-Noise Concrete Vibrator Shaft 

 
Product Introduction:
The doing work part of the vibrator is a rod-formed hollow cylinder with an eccentric vibrator inside, which is rotated at high velocity underneath the motor to generate higher-frequency micro-vibration. The vibration frequency can get to 12000~15000 instances/min.

Basic principle:
There is an electromagnetic coil in the electromagnetic vibrator, via the electromagnetic
The doing work principle of the vibrator is demonstrated in the figure
The operating basic principle of the vibrator is demonstrated in the figure
The present of the coil is a pulse present that is 50 %-wave rectified. In the constructive 50 percent wave, the current passes, the electromagnet has suction, and the vibrating plate is attracted in the adverse 50 percent wave, no present passes, the electromagnet suction disappears, and the vibrating plate returns to the first situation owing to the action of the spring, and gives The coal channel is connected to the vibrating plate, so that below the motion of the electromagnetic vibrator, the coal channel is continually vibrated.

Functions:
one.Practical and comfortable to run thanks to the design of the motor and mild weight 
two.CZPT-insulation for the motor enhance the secure procedure greatly 
3.Operating with the solitary period electrical power offer, quite suitable for specific use.
four.Often straightforward and ease to handle and operation.

Parameter:

Design: MC-EH-25 MC-EH-32 MC-EH-forty MC-EH-48 MC-EH-fifty eight
VIibrator CZPT Dia: twenty five 32 40 forty eight 58
VPM: 12000~17000
RPM: 9500~14000
Vibrating Amplitude(mm): .eight 1 one.2 1.3 1.five
Dia of Flexible Hose(mm) twenty five 30 30 30 36

 

 

Information:

 

Electronic Inverter Low-Noise Concrete Vibrator Shaft