| Basic Knowledge | Dimension(mm) | 32×35.5×16.five | |
| Weight ( g ) | ≈35g | ||
| Speak to Arrangement | 1A/1B | ||
| Contact Content | AgSnO2 | ||
| Ambient Temperature | -45~+85ºC | ||
| Vibration | ten~50Hz,.075mm | ||
| Shock | 1000m/s²,(100g) | ||
| Specification Info | Nominal Voltage | nine~36VDC | |
| Electricity Use | <1.5W | ||
| Operating Voltage | seven.2V | ||
| Max. Motor Voltage | 36V | ||
| Max. Switching Present | 90A | ||
| Surge Current | 2500A/10ms | ||
| Motor Resistance(R±15%) | 60Ω | ||
| Make contact with Voltage | <60mV | ||
| Make contact with Resistance | <0.6mΩ | ||
| Dielectric Strength | Motor to Make contact with | >4000VAC 1min | |
| Throughout Open up Make contact with | >2000VAC 1min | ||
| CZPTal Existence | >10000cycles | ||
| Mechanical Existence | >100000cycles | ||
| Pulse Time | 100ms~150ms | ||
| Finding-up Time | <65ms | ||
| Release Time | <65ms | ||
| Insulation Resistance | >1000MΩ(500VDC) | ||
Cautions of Latching Relay:
1.Recommendations of relay’s enter
(one)Polarity-Please check the polarity inside of our specialized specification, if single coil then”+ -” or “- +”are good,
you can modify it by one pulse.If double coil then it’s necessary to validate “-+-” or “+-+”prior to leaving the our manufacturing unit.
(2)Driving-Make sure you energize the relay at our suggest pulse width, rated voltage for reliable functionality, if 1.five
times or two moments of benefit or reduced driving issue plz confirm with our engineer.
(3)Relays’contact status could be altered during transportation or set up due to impact of external force,
consequently make sure you reset to the required standing.
2.Suggestions of relay’s output
(one)When deciding on the relay with difficult relationship,make sure you stay away from the exterior drive on load terminals throughout or after
the set up.
(2)When the relay will be connected with screw or bolts to the relays’ terminals, plz make positive your relationship is
fixed and avoid relay from damages or other safety troubles thanks to temp. Rise..
(3)The sampling sign wires of goods are minimal, please do not pull or torque for the duration of set up.
